Common Mistakes in Flooring
Problems with floor coverings usually surface a few months after installation. Everything looks fine at first glance, but over time cracks, bubbles, or surface wear begin to appear. At this point most people blame the material, but the real cause is almost always the application process.
The most common mistake is inadequate surface preparation. If the surface is not clean, if the moisture level has not been checked, or if the required primer has not been applied, even the highest-quality Epoxy Flooring can peel away from the surface within a short time. The same applies to Polyurethane Flooring systems.
Another common mistake is wrong product selection. Not every floor system works everywhere. For example, a coating used outdoors must be resistant to water and temperature changes. In such areas, systems like Stone Carpet or Sandy Polyurethane should be preferred. Otherwise deformation is inevitable in a short time.
In interior spaces, because aesthetics are front and center, technical details can be overlooked. Microcement and Micro Concrete applications are thin coating systems that faithfully reflect every flaw in the substrate. If the surface is not even, the result will not be satisfactory no matter how good the material is.
In industrial buildings and factories, the biggest mistake is underestimating the substructure. When Industrial Screed and Surface Hardener applications are not done correctly, the surface will begin to wear and dust no matter what coating is applied on top. This both increases maintenance costs and reduces user comfort.
In decorative applications, speed is usually prioritized. Curing times are not waited out so the project meets its deadline, or coats are applied incompletely. Especially in systems like Aquacement and Cement Terrazzo, this directly affects surface quality.
Mistakes in open-area applications follow a similar pattern. In Stamped Concrete and Colored Patterned Asphalt applications, the right formwork, correct timing, and suitable weather conditions are very important. Rushed jobs quickly suffer from visual deterioration.
In conclusion, success in flooring applications is achieved not just by choosing the right product but by managing the process correctly. Pre-application preparation, the right team, and a patient application process ensure that the floor can be used without problems for many years.
